(For all systems, wigs, extensions, mesh integrations and toppers)
All hair, whether it’s a men’s system, women’s wig, mesh integration or extensions, follows the same core care rules. Think gentle, smooth, and low-friction.
Always brush from the ends upward, supporting the base, roots, bonds or mesh with your hand to prevent tension. Use a mild, moisturising shampoo without sulphates, and apply conditioner only through the mid-lengths and ends. Keep oils, serums and heavy products away from roots, lace, knots, beads, keratin bonds or adhesive lines.
Use heat protectant every time you dry or style and keep tools on medium heat, ideally under 180–190°C. Protect all hair from friction caused by rough fabrics, hoods, scarves or backpacks. A weekly moisture mask or hydrating treatment will keep raw human hair soft and manageable.
2. Sleeping Routine
(For all long-term wear: systems, mesh integration, extensions and wigs worn overnight)
Hair should always be secured before bed to prevent tangling and friction. The correct method is a loose braid or low ponytail positioned gently at the nape.
Sleep on a silk pillowcase to minimise rubbing, dryness and knotting. Cotton absorbs moisture and causes friction; silk keeps the hair smooth and protected. If wearing a removable wig or topper, take it off before sleeping. For semi-permanent pieces such as mesh integrations, men’s systems, or extensions, the braid and silk pillowcase combination is essential.
3. Men’s Hair Systems
(Hard bond and soft bond)
Men’s systems require consistent but gentle upkeep and should never be removed without professional help.
Hard-bond systems stay attached for several weeks at a time. Wash every five to ten days with lukewarm water, keeping movements smooth and downward. Avoid rubbing or scrubbing the base. Condition only the lengths. Do not apply oils or heavy styling products near the hairline. After exercise, clean sweat from the front edge and rinse hair if needed.
Soft-bond and tape-based systems are more sensitive to heat and water exposure at the hairline. Avoid hot water directly over the adhesive. Always use the correct adhesive remover when it is time for removal. Refits are generally required every two to four weeks for soft-bond, and three to five weeks for hard-bond depending on lifestyle.
4. Women’s Pieces
(Wigs, lace units, toppers, mesh integration systems and keratin-bonded mesh bases)
Women’s pieces need careful handling, particularly around lace, mesh, and any integration points.
Brushing should be gentle, starting at the ends and working upward while supporting the lace or mesh with your hand. Do not tug or pull on knots or the hairline. Avoid scratching lace fronts with nails; treat the lace like fine delicate fabric.
Before washing, always detangle thoroughly. Shampoo using downward motions only. Conditioner must stay away from any knots, mesh or bonding areas, and be applied only to mid-lengths and ends.
Mesh Integration Systems
Mesh integration systems combine a breathable mesh with your own natural hair pulled through and secured underneath. Because the mesh and attachment points are delicate, brushing should never be done when the base is wet. Wet mesh stretches and wet keratin or micro-rings loosen.
After washing, the mesh base must be dried completely before you brush the lengths. This strengthens knots, shrinks the mesh back into shape, and re-hardens any keratin used in the attachment. Drying the base first is one of the most important steps in protecting your integration system.
Avoid oils near the mesh. When sleeping, braid the hair and use a silk pillowcase to protect both the integration points and your natural hair underneath.
Keratin-Bonded Mesh Bases
Some integration systems use keratin bonds directly on the mesh. These bonds soften when wet, so brushing wet hair can cause slipping, breakage, or thinning of your own hair. The base must always be completely dry first before touching or brushing the hair. Keep heat tools away from the bonds and avoid conditioners or oils anywhere near the attachment zones.
5. Extensions
(Keratin bonds and microbeads)
Extensions need a different care routine because the attachment points must remain clean and dry.
Brushing should be gentle and supported. Start with the ends, and hold the roots so you’re not pulling on the beads or keratin. Use a loop brush or soft detangling brush specifically designed for extensions.
When washing, tilt the head back rather than forward to prevent tangling at the roots. Apply shampoo between the rows of extensions and rinse downward. Conditioner must stay on the mid-lengths and ends only.
After washing, dry the roots and bonds first. Leaving attachment points wet causes slipping, softening and breakage. Avoid heavy products, root sprays or oils near the bonds. When sleeping, braid or tie into a soft low ponytail and use a silk pillowcase for protection.
Refits depend on the method: keratin bonds usually require maintenance every eight to twelve weeks, while microbeads typically need repositioning every six to eight weeks.
6. Raw Human Hair Care
(For all wigs, systems, integrations and extensions)
Raw human hair behaves differently once it is cut from its original donor. With no natural scalp oils, it becomes drier and needs consistent hydration.
Use moisture masks weekly and a lightweight, non-oily leave-in spray daily. Avoid overwashing, which strips moisture. Keep styling heat moderate and use a protectant every time. Apply oils sparingly and only to the ends to avoid buildup or attachment issues. Protect the hair from UV exposure when in strong sunlight, as raw hair can lighten or dry out easily.